How to Finish Up a Replacement Bolt Handle

There is more to welding on a new bolt handle than just welding it on. In this GunTec presentation Larry Potterfield, Founder and CEO of MidwayUSA, explains the rest of the story when welding on a new bolt handle. He…

How to Finish Up a Replacement Bolt Handle

Source

0
(0)

There is more to welding on a new bolt handle than just welding it on. In this GunTec presentation Larry Potterfield, Founder and CEO of MidwayUSA, explains the rest of the story when welding on a new bolt handle. He starts by heating the shank of the handle with an oxy-acetylene torch until is turns red and the steel is soft enough to bend. Using a box end wrench the bolt handle is lifted slightly and swept back. Once the steel cools the weld can be dressed down suing a variety of files. Once the bolt handle has been shaped, a notch is cut in the receiver to allow clearance for the new handle. This is done with a hand grinder. Just enough material is removed to allow the bolt to fully close. All that’s left is a final polish on the bolt.

0 / 5. 0

Laisser un commentaire

Votre adresse e-mail ne sera pas publiée. Les champs obligatoires sont indiqués avec *